8. Run the Pre-Loaded Demo
This section describes how to quickly get started with the DA1469x ProDK and run the preloaded demo.
Step 1 : Take the daughter board and Plug it to the to main board through the dedicated connector Figure 3. Take care to match the orientation.
Step 2: Connect a USB type A to mini-B USB cable on the micro USB header on the ProDK Main board to power On. The other side of the USB cable can be connected to a PC/Laptop (Figure 6).
Step 3: After the ProDK is powered, and if everything works fine then the following LEDs status can be seen as shown Figure 33
On the daughter board, Red LED 1 is blinking. The LED blinking periods in ms is defined in
config/pxp_reporter_config.h
On the main board Blue LED D1, Green LED 4 and Green LED 5 are ON.
Step 4 The ProDK now starts to advertise over Bluetooth. The Pre-Loaded demo application is executed from QSPI flash. Open your BLE scanner application to scan and connect to the Dialog DA1469x device. Refer to Figure 34
Note
In this example, we used an Android application but you can also use the LightBlue iOS application to connect an iPad/iPod/iPhone device to the application.
Note
The number shown in Figure 34 is aligned with he number observed on the Terminal program Figure 10 for windows.
Step 6 As a Feature, alerting is done using the RED LED available on the daughter board, refer to Figure 33. After connection, you can write value to Alert Level characteristic in Immediate Alert service:
0x00 (No alert) - the white LED on ProDK device does not blink
0x01 (Mild alert) - the white LED on ProDK blinks slow immediately
0x02 (High Alert) - the white LED on ProDK blinks fast immediately